How To Cut Laminate Flooring Uk

These tools will assist you in achieving your desired results.

How to cut laminate flooring uk. The Bullet Tools 9 inch best saw blade for cutting laminate flooring is a powerful cutter. Mitre the end of each piece with a mitre saw set to cut at a 45-degree angle. Make a small mark on the edge of the laminate so you know where to cut or use a chalk pencil to draw your measurement line across the face of the laminate.

You will need to face your board laminate side down on your workmate use the clamps to secure the laminate board in place. Then use a hammer and chisel to remove enough of the bottom of the architrave that the laminate will fit underneath it. Then slot the remaining board into the space being sure to tap on the surface to.

If you notice that jigsaw base is scratching the word you can always put a couple of pieces of tape on it to soften the metal base of the jigsaw and prevent any scraping or gouging that may occur while cutting. Mark and measure where you want to cut the boards beforehand with chalk or pencil. In most of the cases you have to cut the last.

Cutting laminate to length. Be sure to leave a 10-12mm expansion gap. Lower the saw blade so that it cuts through both of the long sides of the laminate plank from end to end.

You can easily wipe the chalk off the surface after you are done cutting2 X Research sourceStep 3 Leave the laminate facing right-side-up and cut. Measure the length required using your tape measure Mark the board for the cut Use your square and pen or pencil to create a straight line across the face of the board Use your cutting tool to make the cut on the waste-side of the line and use a damp cloth to remove any. In order to cut the last laminate board in a row first you have to lay it with the tongue towards the wall.

A Handsaw Circular or Jigsaw. As you touch the wood it will slowly cut into the floor. If you are using a power saw remember that laminate chips easily.