How To Install Laminate Flooring Around Toilet Flange

I would recommend taking the toilet up and extending the flange up the quarter-inch or so additional thickness that the floor will take up and then put it back down.

How to install laminate flooring around toilet flange. Cut the flooring around the drains fairly close to the hole. Create a homemade cutter by inserting one of the screws close to the end of the piece of wood and screw it all the way through the center point on the cement board. Your templates need to be the exact same size as your planks.

You should only have to get a flange extension to raise the flange to the top of the laminate as necessary. It is the best way to do it. The most reliable way to fit the vinyl is to make a template and use it to cut the vinyl before you lay it.

The preferred practice is for the toilet flange. You should always remove porcelain fixtures and install the laminate. Insert the other screw about a ½ inch further from the center screw than the radius of the flange.

By installing the flooring first you will also be able to more easily switch up cabinetry or fixtures without having gaps in the flooring. Place a piece of laminate material as if you were going to snap it together with the already installed pieces so that it overlaps the drain hole and toilet flange. When you lay new sheet vinyl or vinyl tiles in the bathroom you need to remove the toilet and fit the vinyl around the flange which is the metal fitting that holds the toilet down.

You can finish this up nicely by applying a bead of bathroom silicone around the bottom of the toilet where the gap is. Mark the perimeter of the toilet flange with the pencil on the edges of the laminate pieces but add an extra 14 inch of space to allow for expansion and movement of the flooring material with the. When you install the toilet screw it down snugly but not overly tight.

You could floor around it but Id recommend against it. Place each template on the appropriate plank and trace the pattern with a pencil. To do this youll want to measure the size of the hole and cut into pieces to be placed in that area using a jigsaw or circular saw.