How To Install Laminate Flooring Roll

Having the tongue side face down makes it easier to tap the planks together and easier to fasten the planks with nails.

How to install laminate flooring roll. Measure the width of the room from the longest wall and divide the distance by the width of the planks. Hold the block securely with your left hand and hit the block with a hammer in you right hand. 2 What Materials Are Needed To Install Laminate Flooring.

Your Golden Select Laminate flooring is now spill proof. Work evenly along the length of the plank and lightly tap the joint closed using a pull bar and rubber mallet. You need to apply a bead of silicone to the base of the baseboard the part that touches the flooring.

Use adhesive caulk on the back of each laminate plank and carefully press them against the bottom of the wall with the tongue side facing down. Use a wooden block to tap the next row of boards into the first. Be careful not to angle the screwdriver to far down so you dont mess up the floor.

Install the long side tongue into the groove with the end joint aligned. 31 Step 1 Preparing To Install Laminate Flooring. Lay out some of the glue allow it to dry until tacky stick the vinyl roll over it with your roller and repeat the process at the next section.

Go around the room doing this to completion. Fill the entire floor with the vinyl until you reach the edges. Then rotate down to lock.

This is a common DIY mistake. To pull them up just place the tip of the screwdriver at the edge of the strip right where it meets the floor. To close the gap on the long side lift the outside edge of the plank about an inch and push in firmly until the edges meet.