How To Replace Vinyl Click Flooring

Scrape the remaining adhesive with a floor scraper or pry bar.

How to replace vinyl click flooring. Install the vinyl flooring properly. Stack the pieces of click flooring together somewhere out of the way where they will not be damaged. Step 4 - Install the Click Flooring.

Acclimate the vinyl by just opening the boxes not removing the planks and allowing them to sit in a constant temperature between 65 and 85F for 48 hours or more before during and after installation. Videos you watch may be added to the TVs watch history and influence TV recommendations. If playback doesnt begin shortly try restarting your device.

Next find the wall that is parallel to the direction of the boards. Start taking up the click flooring along the nearest wall. Drill two or three more holes on each side of the damaged laminate plank approximately 4 to 5 from each other.

Replace the damaged boards and the remaining boards leading back to the wall. You should be able to take the click flooring apart at the joints. Once its cut gently lift the strip of vinyl until you encounter resistance from the glue near the perimeter.

First and foremost locate the area where the boards are damaged. Scrape the old glue off the subfloor with a floor. Next remove the base moldings and undercut doorways to the thickness of the flooring.

You will need to unclick all of the pieces until your reach the damaged piece keeping the pieces in the right spot for re-installation. Use a heat gun to soften the adhesive if possible. Do not store the flooring on concrete while acclimating.